July 13, 2008
How to break in a Nitro RC engine Part 4
This vid is on how to troubleshoot (TS) your nitro engine Kit. From how to handle flooded engines and other menacing issues such as engine shutting off after braking and more!
This is a ten video rc nitro break in series. The series is designed on how to guide the novice to experienced racing pro or basher on how to break in a nitro rc properly. I will teach the traxxas, new school, and my own method which is a combination of the other two. I will show the user how to prime a nitro rc engine, start the engine using a bump start box, ex starter, roto start, pull start and tiger drive devices. Then, after break in, I will go over nitro engine tuning theory and then show the tuning actally done. This engine tuning series is good for the AE associated electronics Gt GT2 MGT mini MGT hpi savage x ss, traxxas revo tmaxx t maxx s ofna hyper st pro 7 8 9 8. buggy truggy jammin crt crt.5 mini hyper losi lst lst2 lst1 muggy 8ight 8ight-t truggy monster truck mt byt chris mt kyosho 777 sp2 worlds mugen mbx lx comp pro and many more! os engines trx picco sts axial .12 .15 .18 3.3 2.5 .20 .21 .23. 25. 27 .28 .30 .32 collari lrp spec 3 DM
Duration : 0:8:55
Filed under RC Engines by Ray
Comments on How to break in a Nitro RC engine Part 4 »
The 5th tank should …
The 5th tank should be for 3 seconds.
Break ins are not always for "5 tanks". Some you will notice power increases all the way up to 1 gallon. Yours may be this way.
If you are shifting too soon then you will want to adjust your two speed. There is a set screw in the differential that can be adjusted to come on at higher RPMs or lower RPMs. Refer to your manual for that adjustment.
i have a buggy, i …
i have a buggy, i just broke it in traxxas method. but i didnt run the 5th tank full throttle for 2 seconds, i just let it rip. it now shifts to second gear very fast. this worries me. do you konw what i did wrong?
Yes, I had a OS 30 …
Yes, I had a OS 30 that had to do that to. It will loosen the compression to allow it to start.
Has anyone ever …
Has anyone ever tried unscrewing the glow plug a little bit until it gets started? It work for me a couple a times.
Good point! If you …
Good point! If you are having alot of trouble moving the piston then this would be something to try. The hot air gun tends to work well for me on tight pinched sleeves but I could see how extra oil with the heat would do wonders.
forgot to mention …
forgot to mention that u can use after run oil so that its easier to turn if its too hard to turn over.
yeah that was cool:)
yeah that was cool:)
GOOD JOB!
GOOD JOB!
kool as
kool as